Please fill out the contact form below and we will reply as soon as possible.
Repair ricochet damages to target rubber skin In the event of projectiles passing through the target as they are...
February 21st, 2025 947 views 0 likes
February 21st, 2025 842 views 0 likes
The rubber at target is worn by penetrating projectiles. This will eventually cause noise to enter the soundproof measuring chamber...
February 21st, 2025 823 views 0 likes
This target model has one acoustic sensor in each corner. There's also a temperature sensor in the upper right corner...
September 24th, 2025 292 views 0 likes
Worn target rubber skins are picked off target by following steps (general routine): Remove duct tape along edges of the...
September 25th, 2025 220 views 0 likes
Instructions below. Images are taken from different target models, but procedure is equal for different target models: 1 Lie the...
September 25th, 2025 215 views 0 likes
Worn rubber band is simply cut off by scissors. In this case, pay attention not to cut into the main...
September 26th, 2025 251 views 0 likes
Rubber particles and debris will fall to the bottom of the target. Some will pile at the sensors. It is...
September 30th, 2025 263 views 0 likes
I/O cables are pre fabricated to specific lengths. The male and the female I/O cables are connected to the target...
September 30th, 2025 269 views 0 likes
Item Part name KTS part no. 1 The target → Target U5A - eScore → Target H3A - eScore ...
January 2nd, 2026 67 views 0 likes
Item Part name KTS part no. 1 The target → Target H1E - eScore → Target U7E - eScore ...
January 2nd, 2026 65 views 0 likes